Roberts Gorden operation & service Service Manual download pdf (Page 25)

SECTION 5: PROGRAMMING AND OPERATION

19 of 40

SECTION 5: PROGRAMMING AND OPERATION

5.1 Stand Alone Unit

The control has three basic levels of operation /

programming.

By default if a control is not connected to a network,

then it assumes stand alone status.

1. Open level where access is open to anyone at

all times. see Page 20, Section 5.3.2.

2. Manager level, where settings may be changed

for normal operation, accessed through the

manager code, which may be changed to one

that can be remembered by the user. See Page

25, Section 5.5.

3. Engineer level where system settings may be

changed and accessed via engineer code,

which is not changeable. See Page 31, Section

5.6.

The following sections break down tasks available

and detail steps to be taken in each level.

SEQUENCE FOR SETTINGS

Set the functions in the order:

1. Set Configuration; Page 33, Section 5.6.3.

2. Calibrate temperature sensor; Page 36, Sec-

tion 5.6.5.

3. Set optimisation; Page 32, Section 5.6.2.

The remainder of the settings may be undertaken in

any order.

5.2 Network Unit

For network units, all functions of Section 5.1 are

the same. The open level will allow similar functions

on all network controls from a base unit or from any

other network control, dependent on how the

individual units have been site configured. See Page

21, Section 5.4 for options.

Networked units will need to be configured for

network options. See Page 31, Section 5.6.1.

SEQUENCE FOR SETTINGS

1. Configure each control for the network. See

Page 31, Section 5.6.1.

2. Configure each controller for its use with the

engineers code. See Page 31, Section 5.6.

3. Set operational settings with the manager

code. See Page 25, Section 5.5.

Sequences 1 and 2 must be carried out at each

networked station and may be carried out together.

Sequence 3 may be carried out from any "full

control" station for all other stations where operating

times and temperatures may be copied from one

control to another.

5.3 System Language

The ROBERTS GORDON

NRG Control has been

programmed to display in 5 languages.

To select or change the language See Page 19,

Section 5.3.1.

5.3.1 Set System Language

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comments to this Manuals

No comments

Roberts Gorden operation & service Service Manual Page 25

Comments to this Manuals

Related products and manuals for Space heaters Roberts Gorden operation & service